Operator`s manual

17
Troubleshooting, Adjustment, & Service
A
D
C
B
E
Figure 17 - Blade Clutch Adjustment
A. Clutch Rod
B. Clutch Rod Lever
C. Clutch Rod Fitting
D. Locknut
E. Hairpin Clip
BLADE CLUTCH ADJUSTMENT
If the mower blade does not stop running when the blade
clutch lever is in the DISENGAGED position, does not
run at full speed, or the belt squeals while cutting, adjust
the Blade Clutch tension.
1. Remove hairpin clip (E, Figure 17).
2. Slide clutch rod fitting (C) out of blade clutch lever
(B).
3. Loosen locknut (D) and rotate clutch rod fitting on
clutch rod.
4. Reposition clutch rod fitting onto blade clutch lever,
secure with hairpin clip and tighten locknut.
5. Check the blade tension:
a. With the blade clutch lever fully disengaged (han-
dle fully back against control panel), there should
not be any tension on the blade clutch spring. If
there is tension on the spring, the blade clutch will
not release.
6. Repeat adjustment as required.
WARNING
Shut off engine before attempting this adjustment
procedure.