Operating instructions

91
ELECTRONIC CONTROL UNITS
Thanks to the unique performance of the combination of motors
and Optima MX, Optima MX
INT
and DMX control units, no more
than two contra-angle handpieces are now needed for the majority
of dental restoration, prophylaxis or endodontic work, including
procedures using NiTi tools.
With the CA 1:1 and CA 1:5, you have at your disposal a range
of speeds from 100 rpm to 200,000 rpm. This remarkable advance
reduces the number of instruments needed in the dental operatory.
OPTIMA MX
INT
ONE SYSTEM AND TWO
INSTRUMENTS FOR ALL
YOUR DENTISTRY WORK
Table of current possible applications
EXAMPLES OF OPERATIONS POSSIBLE
WITH TWO BIEN-AIR CONTRA-ANGLE HANDPIECES
Applications and contra-angle handpieces CA 1:5 CA 1:1
Minimum speed in rpm 500 100
Maximum speed in rpm 200 000 40 000
Amalgam polishing •
Root treatment - NiTi •
Removal of deep caries •
Removal of caries • •
Hole drilling •
Preparation of temporary crowns and bridges •
Gold and microwire polishing • •
Interdental and subgingival polishing •
Surplus amalgam removal • •
MC Spadden endodontic technique •
Chrome cobalt balance •
General finishing in cavity preparation •
Cutting of retentive grooves • •
Ceramic adjustment •
Finishing preparation B+C, bevels and ridges • •
Finishing preparation B+C, cavities, bevels and ridges •
Occlusal adjustment •
Dentine reduction • •
This table shows possible uses and does not in any way
constitute recommendations for use.