Snow Blower - Snow Thrower User Manual

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
2
3
3
17
13
24
25
26
27
28
29
28
29
30
31
23
26
27
Apply a bead of gasket eliminator into rear seal groove
and flat surface just past groove (Ref. 15 & 20).
Torque to
9 - 11 ft-lbs.
Torque to
9 - 11 ft-lbs.
Torque (Ref. 2) to
9 - 11 ft-lbs.
Hub of pulley to
face of auger.
Locate pulley on worm shaft
(Ref. 10) so the belt is 1.94"
from rear of impeller housing.
Auger stamped "R".
Auger
stamped "L".
Place 1 or 2 washers
as required.
14
TP-400-2001-05-IW-S
© Copyright 1999 Simplicity Manufacturing, Inc. All Rights Reserved.
Auger Drive and Impeller
NOTE: Unless noted otherwise,
use the standard hardware torque
specification chart.
The above parts group applies to the following Mfg. Nos.:
1692680 555M, 5HP Manual Start
1692681 755E, 7HP Electric Start
1692746 755M, 7HP Manual Start (Exp.)
1693161 555M, 5HP Manual Start
1693162 755E, 7HP Electric Start
1693163 555M, 5HP Manual Start (Exp.)
1693164 755M, 7HP Manual Start (Exp.)
1693425 555M, 5HP Manual Start
Continued on next page