Snow Blower - Snow Thrower User Manual

1
2
3
4
3
1
2
3
3
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
24
17
39
40
41
22
24
37
33
38
38
34
33
42
43
44
45
46
32
45
44
32
17
30
52
42
42
48
49
28
50
51
44
31
30
Apply adhesive to
secure grips.
Ref. 18 required on
slotted holes only.
10
Shift rod assembly
(Ref. 53) must pivot freely
on pivot blocks (Ref. 49).
Slot in support (Ref. 37)
towards rear of unit.
Mount bushings with
flange on inside of
brackets.
Insert shift rod (Ref. 46)
into inner hole of Ref.
47.
49 47
Use washers to shim
gear (Ref. 34) as
required to insure proper
adjustment.
Position in slots of frame to be sure hub of gear
(Ref. 37) is tight against the inside surface of the
gear support (Ref. 29).
Locate under rear hole of
gear support (Ref. 29) only.
53
33
6
TP-400-2001-05-IW-S
© Copyright 1999 Simplicity Manufacturing, Inc. All Rights Reserved.
Handles and Controls (Later)
NOTE: Unless noted otherwise,
use the standard hardware torque
specification chart.
The above parts group applies to the following Mfg. Nos.:
1693646 555M, 5HP Manual Start
1693647 555M, 5HP Manual Start (Exp.)
1693648 755M, 7HP OHV Manual Start
1693649 755M, 7HP OHV Manual Start (Exp.)