Specifications

Control Interface Module, Continued
When installing the CIM Display assembly, it is necessary to use a
torque wrench ensure a proper seal while at the same time preventing
damage to the display.
CAUTION
Step Procedure
7. Before installing the new display, remove the protective film
from the display surface.
8. Install the new display on the door. Using a torque wrench
(Siemens part number A5Exxxxxxxx), tighten the six nuts to
a value between 0.34 to 0.56 NM (3 to 5 in lb). Failure to
properly torque the fasteners could result in either loss of
purge or damage to the display.
Note: Cable Routing: When replacing the cables on the CIM-Base
in the following step, take note of the routing. The display
backlight cable runs behind the board standoff as shown on
the left image below. In addition, the display control interface
cable is routed behind the board as shown in the right image
below.
9. Reinstall the CIM-Board hardware, referring back to the
previous procedure titled, CIM-Base Removal and
Installation.
10. Close the door to the Maxum and reapply power.
A5E31405710001 4-11