Specifications

Control Interface Module, Continued

The battery should only be replaced with an approved spare. Contact

Siemens for a replacement.

IMPORTANT

Battery Replacement

Step Procedure

1. Power off the Maxum and then open electronic enclosure

door, using a 4mm (5/32”) Allen wrench if necessary.

Before removal of battery, note location of its positive end when installed

in battery holder. The positive and negative terminals are marked on the

battery.

CAUTION

2. Remove the battery from its mounting bracket located on the

left side of the module. Refer to picture below.

3. When installing the new Lithium Battery in its holder, place

the positive (+) end so it installs per marking on the board

(positive terminal facing up).

4. Before closing door and reapplying AC power, be certain the

battery is securely installed in its holder and polarity, within

holder, is correct.

5. After battery is replaced, current date and time information is

lost. If the analyzer is configured to obtain date and time

information from a central server, then it will update

automatically. If no time server is set, it will be necessary to

manually set the date and time on the analyzer.

Batter

Figure 4-1: CIM Board Battery Location

4-12 A5E31405710001