Specifications

Solenoid Valves
This section presents the procedures for removal or installation of a
Solenoid Valve. The valves are mounted on either the floor or back of the
electronic enclosure, depending on configuration. Valves are replaced
individually using the valve kit noted in the spare parts section of this
manual.
Description
Voltage dangerous to life exists. Before performing the removal and
installation procedures, it is important that primary AC power to the
Maxum II be turned off from the main circuit breaker. Observe all
plant safety requirements before performing any repair or
maintenance on the Maxum II.
WARNING
The following procedure should be followed for removal and installation
of a Solenoid.
Procedure
Step Procedure
1. Turn off power to the Maxum II at the main circuit breaker.
2. Open electronic enclosure door (using a 4mm (5/32”) Allen
wrench if necessary).
3. Unplug the cable to the solenoid to be replaced, as shown
below.
A5E31405710001 4-17