Product Manual

15
Assembly
7. (Manual Lift Models Only) Install the crank bracket
(BA, Figure 18) to the hitch assembly (AN) using
carriage bolt (R) and nut (G) as shown. DO NOT FULLY
TIGHTEN HARDWARE.
8. (Manual Lift Models Only) Insert the hole-end of crank
assembly (BB) through the slot (*) in the crank bracket
(BA) as shown.
BB AN
RG
BA
*
Figure 18
9. (Manual Lift Models Only) Thread nut (K, Figure 19)
and nut (L) onto threaded rod (BC) as shown.
Note: Nut (L) should be flush with end of threaded rod.
The flange of nut (K) should be facing the nut (L).
10. (Manual Lift Models Only) Hook threaded rod
assembly to spring (BD) and hang spring onto the hole-
end of crank assembly (BB).
LBB
BC
BD K
Figure 19
11. Set to the attachment-raised position.
12. (Manual Lift Models Only) Install spring anchor
bracket (BE, Figure 20) into hole (*) in frame using
capscrew (F) and nut (I) as shown. DO NOT FULLY
TIGHTEN HARDWARE.
*
BE
F
I
Figure 20
13. (Manual Lift Models Only) Rotate spring and threaded
rod assembly (BF, Figure 21) over tire and under right
rear fender as shown.
BF
Figure 21
Not for
Reproduction