Product Manual

16
Assembly
14. (Manual Lift Models Only) Seat nut (K, Figure 22) into
spring anchor bracket (BE) by threading the nut (K) up
the threaded rod and entering through the front of the
spring anchor bracket.
K
BE
Figure 22
15. (Manual Lift Models Only) Tighten crank bracket
hardware and spring anchor bracket hardware.
Tiller Installation
(All Models)
1. Set to the attachment-lowered position.
2. Position the tiller on skid behind the tractor.
3. Using two people, lift tiller (BG, Figure 23) and insert lift
assembly shaft (BH) into hitch assembly tube (AN).
BHBG
AN
Figure 23
4. Pivot tiller U-frame assembly (BI, Figure 24) into hitch
assembly bracket (AM) as shown. Secure with two pins
(V) and two safety clips (Y).
AM
BI
Y
V
Figure 24
5. Insert pin (W, Figure 25) through lift assembly shaft and
hitch assembly tube (AM). Secure with safety clip (Y).
YAMW
Figure 25
6. (Manual Lift Models Only) Tension crank by turning
clockwise 20-30 times, or until the length of the
threaded rod between the spring anchor bracket and
the end of the threaded rod assembly measures 5.5” -
6.5“. (Reference lift height adjustment, Figure 34).
Note: To make crank tensioning easier, lift up back
end of tiller and place lift lever in the attachment-raised
(back) position.
Not for
Reproduction