Product Manual

18
Assembly
Belt Cover Installation
(All Models)
1. Secure the front of belt cover (BO, Figure 30) to the
post above the triple pulley assembly using pivot rod
(BP) and safety clip (Y).
BO
Y
BP
Figure 30
Note: Both rear belt guard supports (BQ, Figure 29)
should be in a vertical position.
2. Secure the back of the belt cover (BO, Figure 31) to the
rear belt guard supports (BQ) using the hardware that is
pre-assembled to the cover as shown. See note below
for hardware order.
Note: Hardware Order (from inside of tractor to outside)
Capscrew - Inside Belt Guard Support - Spacer - Cover
- Nylon Washer - Long Spacer - Washer - Spacer -
Outside Belt Guard Support - Lockwasher - Nut
BO
BQ
Figure 31
Not for
Reproduction