Product Manual

22
7. Remove the lift rod assembly (AW, Figure 36) from the
hitch assembly.
8. Remove the tiller from the rear hitches.
AW
Figure 36
9. Manual Lift Models: Remove the pin (AC, Figure
37) securing lift link (AI) from top hole of lift link cam.
Reinstall the pin through the bottom hole in the lift cam
and through the slot in the lift link.
AC
AI
Figure 37
10. Hydraulic Lift Models: Remove the pin securing the
hydraulic cylinder to the top hole in the lift cam. Reinstall
the pin through the slot in the lift cam.
Normal Installation
1. Manual Lift Models: Remove the pin (AC, Figure
38) securing lift link (AI) from bottom hole of lift cam.
Reinstall the pin through the top hole in the lift cam and
through the end hole in the lift link (AI).
AC
AI
Figure 38
2. Hydraulic Lift Models: Remove the pin securing the
hydraulic cylinder to the slot in the lift cam. Reinstall the
pin through the top hole in the lift cam.
3. Attach the tiller to the to the hitch assembly (see Figure
36).
4. Install the lift lever assembly (AY, Figure 35).
5. Install the lift rod assembly (AW, Figure 36).
6. Manual Lift Models: Raise the tiller. Install the spring
and threaded rod assembly (see Figure 34). Lower the
tiller.
7. Install the triple pulley assembly (AP, Figure 33).
8. Install the front pulley assembly (AQ, Figure 32).
9. Route the drive belt as shown in Figure 32.
10. Perform the adjustments listed in the “Trouble-shooting,
Adjustments, and Service” section.
Removal & Normal Installation
Not for
Reproduction