User guide

22 MDX-ETHERNET User Guide
www.leroy-somer.com Issue : a
5.12.4 MDX-ETHERNET IP default gateway Zgateway
IP default gateway Zgateway
This is the least significant octet of MDX-ETHERNET IP default gateway address. When
using DHCP this will be updated from the DHCP server.
5.13 MDX-ETHERNET baud rate
MDX-ETHERNET baud rate
MDX-ETHERNET can be set to automatically detect the baud rate or be fixed at either
10Mbs or 100Mbs.
Table 5.3 MDX-ETHERNET baud rate
5.14 DHCP (Dynamic Host Configuration Protocol)
5.14.1 DHCP enable
This parameter determines if the module gets it's network configuration (IP address,
subnet mask, etc.) from the host drive parameters or from a DHCP server on the
network. The DHCP server can be configured to give the module the next free address
or an address based on the MAC address of MDX-ETHERNET.
Table 5.4 MDX-ETHERNET DHCP enable
A DHCP server will typically provide MDX-ETHERNET with an IP address, subnet
mask, default gateway and DNS information.
Pr 15.71
Default 254
Range 0 to 255
Access RW
Pr 15.04
Default 0 (automatic)
Range 0 to 4
Access RW
Pr 15.04 (LCD display) Baud rate
0 (Automatic) Automatic detect
1 (10 MB half DX) 10 MB half Duplex
2 (10 MB full DX) 10 MB full Duplex
3 (100 MB half DX) 100 MB half Duplex
4 (100 MB full DX) 100 MB full Duplex
This parameter should normally be left in the auto detect state.
NOTE
Pr 15.55
Default 0 (no)
Range 0 to 1
Access RW
Pr 15.55 (LCD display) DHCP enable
0 (no) Use local configuration
1 (yes) Use DHCP server