User guide

MDX-ETHERNET User Guide 43
Issue : a www.leroy-somer.com
12.2 Module ID code
The module ID code indicates the type of module fitted in to the drive corresponding to
menu 15. The module ID code for MDX-ETHERNET is 147.
12.3 Module firmware version
The software version of the option module can be identified by looking at Pr 15.02 and
Pr 15.51.
The software version takes the form of xx.yy.zz, where Pr 15.02 displays xx.yy and
Pr 15.51 displays zz (e.g. for software version 01.01.00, Pr 15.02 will display 1.01 and
Pr 15.51 will display 0).
12.4 Node address
Each node on a MDX-ETHERNET network must be given a unique network node
address.
The MDX-ETHERNET must be re-initialised to make a change of node address active.
See section 5.10 Setting the IP address or section 5.14 DHCP for more information.
12.5 MDX-ETHERNET baud rate
MDX-ETHERNET can be set to automatically detect the baud rate or be fixed at either
10Mbs or 100Mbs.
Table 12.4 Table 12.1 MDX-ETHERNET baud rate
Module ID code
Pr 15.01
Default 147
Range 0 to 499
Access RO
Firmware - major version (xx.yy)
Pr 15.02
Default N/A
Range 00.00 to 99.99
Access RO
Firmware - minor version (zz)
Pr 15.51
Default N/A
Range 0 to 99
Access RO
MDX-ETHERNET baud rate
Pr 15.04
Default 0 (automatic)
Range 0 to 4
Access RW
Pr 15.04 (LCD display) Baud rate
0 (Automatic) Automatic detect
1 (10 MB half DX) 10 MB half Duplex
2 (10 MB full DX) 10 MB full Duplex
3 (100 MB half DX) 100 MB half Duplex
4 (100 MB full DX) 100 MB full Duplex
This parameter should normally be left in the auto detect state.
NOTE