User guide

48 MDX-ETHERNET User Guide
www.leroy-somer.com Issue : a
13.3 Restore defaults
If the host drive is defaulted (see the drive user guide for details) it will also clear the
current configuration of the fitted MDX-ETHERNET. Setting Pr 15.30 to 1 additionally
clears the backup copy of the stored MDX-ETHERNET configuration.
This can be performed as follows:
•Set Pr 15.30 to 1 (ENABLED).
• Modbus TCP communications will be stopped.
• The host drive will load and store its default parameter values.
• Default parameter values for the MDX-ETHERNET will be loaded.
• The MDX-ETHERNET will reset and re-initialise using the default values.
13.4 Disable full write access with acyclic or web page
This parameter will restrict a remote user's access to the drive. Pr 15.36 = read only
ensures that write access to the drive is disabled. Pr 15.36 = read write allows full
access to the drive parameters. With this parameter enabled, access with acyclic is not
allowed.
13.5 E-mail configuration
MDX-ETHERNET provides the facilities for sending e-mail alerts. These e-mails are
configured based on a trigger condition with Pr 15.54.
13.5.1 Requirements
In order to send e-mails you will need the following:
• A mail server that accepts SMTP connections and password if they have.
• An e-mail address for MDX-ETHERNET.
• The IP address of the mail server.
13.5.2 Setup
To setup e-mail on MDX-ETHERNET you must first be logged in with appropriate
permissions. From the General configuration menu then select E-mail settings option on
the menu. Enter the IP address and password of the mail server click on "store setting"
to save the settings.
Restore defaults
Pr 15.30
Default 0 (disabled)
Range 0 to 1
Access RW
Disable full write access
Pr 15.36
Default 0 (read write)
Range 0 to 1
Access RW
It is recommended that the address used is part of the standard corporate address
structure (i.e. [e-mail]), contact your system administrator for
advice on obtaining an e-mail address. MDX-ETHERNET will not receive e-mail, and
facilities should be put in place to prevent mail going to this account residing on the
server.
NOTE