User guide

8 MDX-ETHERNET User Guide

www.leroy-somer.com Issue : a

3 Mechanical installation

3.1 General Installation

The installation of an option module is illustrated in Figure 3-1.

Figure 3-1 Fitting a MDX-ETHERNET

First, remove the mask which protects the option connector slot on the drive control

board (1). The option module connector is located on the underside of the module.

Push this into the option module slot located on the drive until it clicks into place (2).

Screw the module to secure it onto the drive (3).

For further information, refer to the appropriate drive manual.

Before installing or removing an option module in any drive, ensure the AC supply has

been disconnected for at least 10 minutes and refer to Chapter 1 Safety and operating

instructions. If using a DC bus supply ensure this is fully discharged before working on

any drive or options modules.

WARNING