Product Manual

10
www.simplicitymfg.com
Throttle Control
The throttle controls engine speed. Move the
throttle forward to increase engine speed and back
to decrease engine speed. Always operate at FULL
throttle.
Choke
Close the choke for cold starting. Open the choke
once the engine starts. A warm engine may not
require choking. Pull the knob UP to close the
choke. Push to knob DOWN to open the choke.
General Operating Safety
Before first time operation:
• Be sure to read all information in the Safety and
Operation sections before attempting to operate
this mower.
• Become familiar with all of the controls and how to
stop the unit.
• Drive in an open area without mowing to become
accustomed to the unit.
Checks Before Starting
• Check that crankcase is filled to full mark on the
dipstick. See the engine Operator’s Manual for
instructions and oil recommendations.
• Make sure all nuts, bolts, screws and pins are in
place and tight.
• Make sure fuel shut off valve is in the ON position.
• Fill the fuel tank with fresh fuel. Refer to engine
manual for fuel recommendations.
Operation
WARNING
• Before leaving the operator’s position for any
reason, engage the parking brake, disengage the
PTO, stop the engine and remove the key.
• To reduce fire hazard, keep the engine and mower
free of grass, leaves and excess grease. Do
NOT stop or park rider over dry leaves, grass or
combustible materials.
• Gasoline is highly flammable and must be handled
with care. Never fill the tank when the engine is
still hot from recent operation. Do NOT allow open
flame, smoking or matches in the area. Avoid
over-filling and wipe up any spills.
WARNING
Read the Operator’s Manual before
attempting to operate the machine.
• If you do not understand how a specific control
functions, or have not yet thoroughly read the
FEATURES and CONTROLS section, do so now.
• Do NOT attempt to operate the mower without first
becoming familiar with the location and function of
ALL controls.
Ground Speed Control
Handles Operator Presence
These handles control the ground speed of the
mower. The left and right handles are tied together
so you can operate either lever to control the
mower’s ground speed.
Moving a handle forward towards “F” increases the
FORWARD speed of the mower. Moving a handle
back towards “R” increases the REVERSE speed.
Moving the handles to “N” neutral position stops
mower travel.
NOTE: The further a handle is moved away from the
neutral position the faster the mower will travel.
Engine Kill / Operator Presence
Handles
These handles are a major factor in the safety
interlock system of the mower. Both handles are tied
together so depressing one handle depresses both.
The operator must depress the handles in order
to deactivate the engine kill system. Handles must
be depressed to disengage the parking brake and
engage the PTO switch.
FEATURES & CONTROLS
Cutting Height Adjustment Handle
The cutting height adjust handle controls the mower
cutting height. To adjust the mower cutting height,
turn the crank handle clockwise to raise the cutting
height. Turn the crank handle counterclockwise to
lower the cutting height. Observe the cutting height
indicator on the left side of the mower deck.
Not for
Reproduction