Product Manual

Check Engine Oil Level
Interval: Before Each Use
Refer to the engine owners manual for dipstick and oil fill
locations and specific engine oil check and fill procedures.
Check Hydraulic Oil Level
Interval: Before Each Use
1. Before removing the reservoir cap, make sure the area
around the reservoir cap and fill neck of the reservoir is free
of dust, dirt, or other debris.
2. Unscrew the reservoir cap (A, Figure 6).
6
3. Look down the filler neck of the hydraulic oil reservoir (B)
and observe the oil level. When cold, the oil level should be
approximately 4” (10 cm) below top of the filler neck.
4. If necessary, add either Mobil 1™, 15W-50 synthetic oil or
Castrol Syntec™ 5W-50 oil. DO NOT use conventional oils.
5. Reinstall the reservoir cap.
Seat Adjustment
The seat can be adjusted forward and back. Move the lever (A,
Figure 7) towards the left, position the seat as desired, and
release the lever to lock the seat into position.
7
Mowing Height Adjustment
The cutting height adjustment pin (A, Figure 8) controls the
mower cutting height. The cutting height is adjustable between
1-3/4” (4,4 cm) and 5” (12,7 cm) in 1/4” (0,64 cm) increments.
8
1. Depress the deck lift foot pedal (B) until it locks into the 5”
(12,7 cm) position.
2. Place the cutting height adjustment pin in the desired cutting
height.
3. Depress the deck lift foot pedal then push the lock lever (C)
towards the right to release the lock.
4. Release the deck lift foot pedal until it comes to rest against
the cutting height adjustment pin.
Foot Pedal Adjustment
The deck lift foot pedal can be adjusted to accommodate the
operator’s height for optimal comfort.
To adjust pedal position:
1. Remove the foot pedal (A, Figure 9) from the pedal mount
tab (B).
15
Not for
Reproduction