Product Manual

14
To turn in place, “Zero Turn,” gradually move one ground speed
control lever forward from neutral and one lever back from neutral
simultaneously. Repeat several times.
NOTE: Changing the amount each lever is pulled—forward or
back, changes the “pivot point” you turn on.
Advanced Driving
Execuring an End-Of-Row Zero Turn
15
Your Zero Turn Rider’s unique ability to turn in place allows you
to turn around at the end of a cutting row rather than having to
stop and Y-turn before starting a new row.
For example, to execute a left end-of row zero turn:
1. Slow down at the end of the row.
2. Move the RIGHT ground speed control lever forward slightly
while moving the LEFT ground speed control lever back to
center and then slightly back from center.
3. Begin mowing forward again.
This technique turns the rider LEFT and slightly overlaps the row
just cut —eliminating the need to back up and re-cut missed
grass.
As you become more familiar and experienced with operating
the Zero Turn rider, you will learn more maneuvers that will make
your mowing time easier and more enjoyable.
Remember, the more you practice, the better your control
of the Zero Turn will be!
Mowing
1. Engage the parking brake. Make sure that the PTO switch
is disengaged, the ground speed control levers are locked
in the NEUTRAL position and the operator is in the seat.
2. Start the engine. See Starting the Engine.
3. Set the mower cutting height.
4. Set the throttle to FULL.
5. Engage the PTO by pulling up on the PTO switch.
6. Begin mowing.
7. When finished, shut off the PTO.
8. Stop the engine. See Stopping the Rider.
Mowing Recommendations
Several factors can affect how well your machine cuts grass,
Following proper mowing recommendations can improve the
performance and life of your machine.
Height of Grass
Often cutting height is a matter of personal preference. Typically,
you should mow the grass when it is between three and five
inches high. The proper cutting height range for a specific lawn
will depend upon several factors, including the type of grass, the
amount of rainfall, the prevailing temperature, and the lawn’s
overall condition.
Cutting the grass too short causes weak, thin grass plants, which
are easily damaged by dry periods and pests. Cutting too short
is often more damaging than allowing the grass to be slightly
higher.
Letting grass grow a bit longer—especially when it is hot and
dry—reduces heat build-up, preserves needed moisture and
protects the grass from heat damage and other problems.
However, allowing grass to grow too high can cause thin turf and
additional problems.
Cutting off too much at one time shocks the plant’s growth system
and weakens the grass plants. A good rule of thumb is the
1/3 rule: to cut no more than one third of the grass height,
and never more than 1 inch at a time.
18 SimplicityMfg.com
Not for
Reproduction