Product Manual

Throttle Control: The throttle controls engine speed. Move the
throttle forward to increase engine speed and back to decrease
engine speed. Always operate at FULL throttle.
PositionIcon
Fast throttle speed.
Slow throttle speed.
Hour Meter: The hour meter measures the number of
hours the PTO has been engaged. The hour meter has a self
contained power source so the total hours are always visible.
Operation
Before First Time Operation
• Be sure to read all information in the Safety and Operation
sections before attempting to operate this tractor and mower.
• Become familiar with all of the controls and how to stop the
unit.
• Drive in an open area without mowing to become
accustomed to the unit.
WARNING
• Never operate on slopes greater than 15°.
• Select slow ground speed before driving onto a slope. Use
extra caution when operating on slopes with a
rear-mounted grass catcher.
• Mow across the face of slopes, not up and down, use
caution when changing direction on slopes and do NOT
start or stop on a slope.
WARNING
• Never allow passengers to ride on the unit.
• Before leaving the operator’s position for any reason,
engage the parking brake, disengage the PTO, stop the
engine and remove the key.
• To reduce fire hazard, keep the engine, rider and mower
free of grass, leaves and excess grease. Do NOT stop or
park rider over dry leaves, grass or combustible materials.
• Fuel is highly flammable and must be handled with care.
Never fill the tank when the engine is still hot from recent
operation. Do NOT allow open flame, smoking or matches
in the area. Avoid over-filling and wipe up any spills.
WARNING
Do NOT load this zero-turn rider on a trailer or truck using two
separate ramps. Only use a single ramp that is at least one
foot wider than the width of the rear wheels of this rider. This
rider has a zero turning radius and the rear wheels could fall
off the ramps, or the rider could tip over injuring the operator
or bystanders.
Checks Before Starting
• Check that the crankcase is filled to the full mark on the
crankcase oil fill and dipstick. If necessary, add oil through
the engine oil fill. See the engine Operator’s manual for
instructions, engine oil dipstick location and oil
recommendations.
• Make sure all nuts, bolts, screws and pins are in place and
tight.
• Adjust the seat position, and make certain you can reach all
the controls from operator’s position.
• Fill the fuel tank with fresh fuel. Refer to engine manual for
fuel recommendations.
• Check the hydraulic oil level.
Starting the Engine
WARNING
• If you do not understand how a specific control functions,
or have not yet thoroughly read the Features & Controls
section, do so now.
• Do NOT attempt to operate the tractor without first
becoming familiar with the location and function of all
controls.
1. While sitting in the operator's seat, engage the parking brake
and make sure the PTO switch is disengaged and the ground
speed control levers are locked in the neutral position.
2. A warm engine may not require choking. Set the engine
throttle control to FAST throttle position. Then fully close the
choke by pulling the knob OUT fully.
3. Insert the key into the ignition switch and turn it to START.
4. After the engine starts, gradually open the choke (push knob
down fully). Reduce to half throttle speed and allow engine
to warm. Warm up the engine by running it for atleast a
minute before engaging the PTO switch or driving the rider.
14 SimplicityMfg.com
Not for
Reproduction