Product Manual

38
5. Repeat this process for the other side of the unit.
NOTE: The hair pins must be installed in the same range in
each roller support shaft for the rear roller bar to be level.
Foot Pedal Adjustment
The deck lift foot pedal can be adjusted to accommodate the
operator’s height for optimal comfort.
To adjust pedal position:
1. Remove the foot pedal (A, Figure 39) from the pedal mount
tab (B).
39
2. Remove the pedal mount hardware (C) and rotate the tab
180 degrees.
3. Reinstall the pedal mount hardware and tighten securely.
4. Reinstall the foot pedal on the pedal mount tab in the proper
orientation as shown in Figure 39.
Floor Pan Removal & Installation
This unit is equipped with a removable floor pan which can be
removed to provide better access to the mower deck.
1. Loosen and remove the retaining nut (A, Figure 40) that
secures the floor pan to the frame of the unit.
40
2. Tilt the back end of the floor pan up and then remove it from
the unit.
3. To re-install the floor pan: Reverse the removal procedure.
Neutral Adjustment
The neutral system for this mower consists of two neutral linkage
rods and a pivot that connect the ground speed control lever to
the transmission. The lower rod that connects the transmission
to the pivot is factory preset and should not be changed for
neutral adjustment purposes. The adjustment is achieved by
changing the length of the upper rod (A, Figure 41) that connects
the ground speed control lever to the pivot.
28 SimplicityMfg.com
Not for
Reproduction