User Manual

9
Your device has four (4) preprogrammed volume
settings. Each time you push down on the volume
select button the volume will increase or decrease.
Simply push in and release the volume button
with the tip of your nger. You will hear one to four
“beeps” each time you press the volume button (see
chart below).
If you start to hear “beeps” several minutes after
making a volume selection, this may be the Low Bat-
tery Alert System. Refer to page 2 for details.
“beep”
“beep, beep”
“beep, beep, beep”
“beep, beep, beep, beep”
Push the button “in”
towards the device
VOLUME CONTROL
DEVICE FEEDBACK
16
What is that squealing sound?
If you hear a constant squealing sound coming from your device, that is
called “feedback”. This caused by the amplied sounds from the sound
port being reected back into the device microphone. Inserting the
device with the volume too high or having your hand too close will
cause this eect. This is normal occurrence with amplication devices.
If your are experiencing any feedback problems, try one or more of the
following suggestions:
• check to ensure dome tip is fully inserted into your ear canal
• make sure left device (blue) is in left ear and (red) for the right
• change the volume level
• inspect the sound port for ear wax blockage
Using the telephone
Your Simplicity device allows you to use the telephone in a completely
normal manner. Place the receiver to your ear as usual. If you hear a high-
pitched whistling noise (feedback) tilt the receiver slightly away from
your ear until the noise stops.
If you hear...
One “beep” indicates the
lowest volume setting.
Four “beeps” is the highest
volume setting.