User Manual

12 13
Removing the polytube
Hold the device in one hand while hold-
ing the polytube (at connector base) in the
other. Pull the polytube and device apart
with a slight twisting motion (g. 1).
Be sure to pull at the base of the tube where
it inserts in to the device, otherwise damage
to the tubing could occur.
Cleaning the poly-tube
Slowly insert the cleaning lament end of
the multi-tool into the base of the poly-
tube (g. 3). Push the lament through the
dome completely to ensure all debris has
been pushed out. If you are unable to clear
the blockage, contact customer support
(see page 21).
Reinserting the poly-tube
Reinsert the ex dome on to the poly-
tube, then insert tubing connector into
opening of the device with a slight back
and forth twisting motion and push into
place. Rotate the poly-tube back to its orig-
inal position (g. 4). View the DVD included
with this device for demonstration of these
procedures.
Replace the polytube if it is bent, cracked,
or discolored.
The polytube base should “pop out” if it is
removed correctly (g.2).
If needed, remove the dome ex-tip from
the poly-tube by gently twisting the poly-
tube and pulling the dome tip. Do not pull
the dome by the outer edge, hold the dome
at the base where it connects to the tubing.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
POLYTUBE CARE
POLYTUBE CARE