Specifications

set ip ssh
Chapter 8
IP Services Commands
123
l set snmp community on page 130
l set snmp usm on page 146
l set snmp notify profile on page 132
l show snmp community on page 173
set ip ssh
Changes the TCP port number on which a UNIVERGE WL Controller listens for
Secure Shell (SSH) management traffic.
Syntax set ip ssh port port-num
Defaults The default SSH port number is 22.
Access Enabled.
Examples The following command changes the SSH port number on a
UNIVERGE WL Controller to 6000:
PROMPT# set ip ssh port 6000
success: change accepted.
See Also
l set ip ssh server on page 124
l set ip ssh server on page 124
l set ip ssh server on page 124
Caution! If you change the SSH port number from an SSH session,
UNIVERGE WL Control System immediately ends the session. To open a new
management session, you must configure the SSH client to use the new TCP
port number.
port-num TCP port number.