Specifications

set ntp server

Chapter 8

IP Services Commands

128

set ntp server

Configures a UNIVERGE WL Controller to use an NTP server.

Syntax

set ntp server ip-addr

Defaults

None.

Access

Enabled.

Usage

You can configure up to three NTP servers. UNIVERGE WL Control

System queries all the servers and selects the best response based on the method

described in RFC 1305, Network Time Protocol (Version 3) Specification,

Implementation and Analysis.

To use NTP, you also must enable the NTP client with the set ntp command.

Examples

The following command configures a UNIVERGE WL Controller to

use NTP server 192.168.1.5:

PROMPT# set ntp server 192.168.1.5