Specifications

set snmp notify target
Chapter 8
IP Services Commands
141
SNMPv2c with Traps
To configure a notification target for traps from SNMPv2c, use the following
command:
Syntax set snmp notify target target-num ip-addr[:udp-port-number]
v2c community-string trap
[profile profile-name]
retries num Specifies the number of times the
UNIVERGE WL Control System SNMP
engine will resend a notification that has not
been acknowledged by the target. You can
specify from 0 to 3 retries.
timeout num Specifies the number of seconds
UNIVERGE WL Control System waits for
acknowledgement of a notification. You can
specify from 1 to 5 seconds.
target-num ID for the target. This ID is local to the
UNIVERGE WL Controller and does not
need to correspond to a value on the target
itself. You can specify a number from 1 to
10.
ip-addr[:udp-port-number] IP address of the server. You also can
specify the UDP port number to send
notifications to.
community-string Community string.
profile profile-name Notification profile this SNMP user will use
to specify the notification types to send or
drop.