Specifications

set snmp security
Chapter 8
IP Services Commands
144
Defaults All SNMP versions are disabled by default.
Access Enabled.
Usage SNMP requires the UNIVERGE WL Controller system IP address to be
set. SNMP does not work without the system IP address.
You also must enable the SNMP service using the set ip snmp server command.
Examples The following command enables all SNMP versions:
PROMPT# set snmp protocol all enable
success: change accepted.
See Also
l set ip snmp server on page 122
l set snmp community on page 130
l set snmp notify target on page 137
l set snmp notify profile on page 132
l set snmp security on page 144
l set snmp usm on page 146
l show snmp status on page 174
set snmp security
Sets the minimum level of security UNIVERGE WL Control System requires for
SNMP message exchanges.
enable Enables the specified SNMP version(s).
disable Disables the specified SNMP version(s).