Specifications

set timezone
Chapter 8
IP Services Commands
155
l show timedate on page 176
l show timezone on page 177
set timezone
Sets the number of hours, and optionally, the number of minutes, that the
UNIVERGE WL Controller real-time clock is offset from Coordinated Universal
Time (UTC). These values are also used by Network Time Protocol (NTP), if it is
enabled.
Syntax set timezone zone-name {-hours [minutes]}
Defaults If this command is not used, then the default time zone is UTC.
Access Enabled.
Examples To set the time zone for Pacific Standard Time (PST), type the
following command:
Controller# set timezone PST -8
Timezone is set to 'PST', offset from UTC is -8:0 hours.
See Also
l clear summertime on page 105
l clear timezone on page 107
l set summertime on page 151
l set timedate on page 154
l show summertime on page 175
zone-name Time zone name of up to 32 alphabetic characters. You can
use a standard name or any name you like.
- Minus time to indicate hours (and minutes) to be subtracted
from UTC. Otherwise, hours and minutes are added by
default.
hours Number of hours to add or subtract from UTC.
minutes Number of minutes to add or subtract from UTC.