Specifications

show ntp
Chapter 8
IP Services Commands
171
Examples To display NTP information for a UNIVERGE WL Controller, type
the following command:
PROMPT> show ntp
NTP client: enabled
Current update-interval: 20(secs)
Current time: Fri Feb 06 2004, 12:02:57
Timezone is set to 'PST', offset from UTC is -8:0 hours.
Summertime is enabled.
Last NTP update: Fri Feb 06 2004, 12:02:46
NTP Server Peer state Local State
---------------------------------------------------
192.168.1.5 SYSPEER SYNCED
Table 23 describes the fields in this display.
Table 23. Output for show ntp
Field Description
NTP client State of the NTP client. The state can be one of the
following:
• Enabled
• Disabled
Current update-interval Number of seconds between queries sent by the
UNIVERGE WL Controller to the NTP servers for
updates.
Current time System time that was current on the UNIVERGE
WL Controller when you pressed Enter after typing
the show ntp command.
Timezone Time zone configured on the UNIVERGE WL
Controller. UNIVERGE WL Control System offsets
the time reported by the NTP server based on the
time zone.
Note: This field is displayed only if you change the
time zone.