Specifications

set enablepass
Chapter 3
Access Commands
19
set enablepass
Sets the password that provides enabled access (for configuration and monitoring)
to the UNIVERGE WL Controller.
Syntax set enablepass
Defaults None.
Access Enabled.
Usage After typing the set enablepass command, press Enter. If you are entering
the first enable password on this UNIVERGE WL Controller, press Enter at the
Enter old password prompt. Otherwise, type the old password. Then type a
password of up to 32 alphanumeric characters with no spaces, and reenter it at the
Retype new password prompt.
Examples The following example illustrates the prompts that the system displays
when the enable password is changed. The passwords you enter are not displayed.
PROMPT# set enablepass
Enter old password: old-password
Enter new password: new-password
Retype new password: new-password
success: Password changed
See Also
l disable on page 17
l enable on page 17
Note. The enable password is case-sensitive.
Caution! Be sure to use a password that you will remember. If you lose the
enable password, the only way to restore it causes the system to return to its
default settings and wipes out the configuration.