Specifications

System Services Commands
21
4
System Services Commands
Use system services commands to configure and monitor system information for a
UNIVERGE WL Controller. This chapter presents system services commands
alphabetically. Use the following table to located commands in this chapter based
on their use.
Auto-Config set auto-config on page 26
Display clear banner motd on page 22
set banner motd on page 29
show banner motd on page 39
set confirm on page 29
set length on page 30
System Identification set prompt on page 31
set system name on page 38
set system location on page 37
set system contact on page 32
set system countrycode on page 33
set system idle-timeout on page 35
set system ip-address on page 36
show load on page 39
show system on page 40
clear system on page 23
clear prompt on page 23
Help help on page 25
History history on page 26