Specifications

set mobility-domain mode member seed-ip
Chapter 10
Mobility Domain Commands
252
success: change accepted.
PROMPT# set mobility-domain member 192.168.1.9
success: change accepted.
PROMPT# set mobility-domain member 192.168.1.10
success: change accepted.
See Also
l clear mobility-domain member on page 250
l set mobility-domain mode seed domain-name on page 253
l show mobility-domain config on page 254
set mobility-domain mode member seed-ip
On a nonseed UNIVERGE WL Controller, sets the IP address of the seed
UNIVERGE WL Controller. This command is used on a member UNIVERGE
WL Controller to configure it as a member. If the UNIVERGE WL Controller is
currently part of another Mobility Domain or using another seed, this command
overwrites that configuration.
Syntax set mobility-domain mode member seed-ip ip-addr [key hex-bytes]
Defaults None.
Access Enabled.
Examples The following command sets the current UNIVERGE WL Controller
as a nonseed member of the Mobility Domain whose seed has the IP address
192.168.1.8:
PROMPT# set mobility-domain mode member seed-ip 192.168.1.8
ip-addr IP address of the Mobility Domain member, in dotted
decimal notation.
key hex-bytes Fingerprint of the public key to use for UNIVERGE WL
Controller-UNIVERGE WL Controller security. Specify
the key as 16 hexadecimal bytes. Use a colon between each
byte, as in the following example:
00:11:22:33:44:55:66:77:88:99:aa:bb:cc:dd:ee:ff