Specifications

show network-domain
Chapter 11
Network Domain Commands
264
Syntax show network-domain
Defaults None.
Access Enabled.
Examples The output of the command differs based on whether the UNIVERGE
WL Controller is a member of a Network Domain or a Network Domain seed. To
display Network Domain status, type the following command:
PROMPT# show network-domain
On a UNIVERGE WL Controller that is a Network Domain member, the
following output is displayed:
PROMPT# show network-domain
Member Network Domain name: California
Member State Mode Mobility-Domain
--------------- -------------- ------ ---------------
10.8.107.1 UP SEED default
On a UNIVERGE WL Controller that is a Network Domain seed, information is
displayed about the Network Domains that UNIVERGE WL Controller is a
member, as well as Network Domain seeds with that the UNIVERGE WL
Controller has a peer relationship. For example:
PROMPT# show network-domain
Network Domain name: California
Peer State
--------------- --------------
10.8.107.1 UP
Member State Mode Mobility-Domain
--------------- -------------- ------ ---------------
10.1.0.0 DOWN SEED
Member Network Domain name:
Member State Mode Mobility-Domain
--------------- -------------- ------ ---------------
10.8.107.1 UP MEMBER default
10.1.0.0 DOWN SEED
Table 29 describes the fields in the display.