Specifications

AP Commands
267
12
AP Commands
Use AP commands to configure and manage AP. Be sure to do the following
before using the commands:
l Define the country-specific IEEE 802.11 regulations on the UNIVERGE WL
Controller. (See set system countrycode on page 33.)
l Install the AP and connect it to a port on the UNIVERGE WL Controller.
l Configure an AP. (See set ap on page 54.)
This chapter presents AP commands alphabetically. Use the following table to
locate commands in this chapter based on their use.
Caution! Changing the system country code after AP configuration disables
AP and deletes their configuration. If you change the country code on a
UNIVERGE WL Controller, you must reconfigure all AP.
Automatic
Configuration of
UNIVERGE WL Access
Points
set ap auto on page 277
set ap auto mode on page 279
set ap auto radiotype on page 281
set ap auto persistent on page 280
set ap bias on page 282
set ap blink on page 283
set ap radio auto-tune max-power on page 292
set ap radio mode on page 295