Specifications

clear ap radio
Chapter 12
AP Commands
272
Syntax clear ap ap-number radio {1 | 2 | all}
Defaults The clear ap radio command resets the radio to the default settings
listed in Table 30 and in Table 33 on page 317.
ap ap-number Index value that identifies the UNIVERGE WL Access
Points on the UNIVERGE WL Controller.
radio 1 Radio 1 of the UNIVERGE WL Access Points.
radio 2 Radio 2 of the UNIVERGE WL Access Points. (This option
does not apply to single-radio models.)
radio all All radios on the AP.
Table 30. Radio-Specific Parameters
Parameter Default Value Description
antenna-
location
indoors Location of the radio antenna.
Note: This parameter applies only to
UNIVERGE WL Access Points models
that support external antennas.
antennatype For most UNIVERGE WL
Access Points models, the
default is internal.
UNIVERGE WL Control System
external antenna model
Note: This parameter applies only to
UNIVERGE WL Access Points models
that support external antennas.
auto-tune
max-power
Highest setting allowed for
the country of operation or
highest setting supported on
the hardware, whichever is
lower
Maximum percentage of client
retransmissions a radio can experience
before RF Auto-Tuning considers
changing the channel on the radio.
channel • 802.11b/g—6
• 802.11a—Lowest valid
channel number for the
country of operation
Number of the channel in which a radio
transmits and receives traffic