Specifications

set ap auto persistent
Chapter 12
AP Commands
280
Usage You must use the set ap auto command to create the profile before you
can enable it.
Examples The following command enables the profile for automatic UNIVERGE
WL Access Points configuration:
PROPMT# set ap auto mode enable
success: change accepted.
See Also
l set ap auto on page 277
l set ap auto persistent on page 280
l set ap auto radiotype on page 281
l set ap bias on page 282
l set ap blink on page 283
l set ap radio auto-tune max-power on page 292
l set ap radio mode on page 295
l set ap radio radio-profile on page 296
l set ap upgrade-firmware on page 300
set ap auto persistent
Converts a temporary UNIVERGE WL Access Points configuration created by
the UNIVERGE WL Access Points configuration profile into a persistent
UNIVERGE WL Access Points configuration on the UNIVERGE WL Controller.
Syntax set ap auto persistent [ap-number | all]
ap-number Index value that identifies the UNIVERGE WL Access
Points on the UNIVERGE WL Controller.
all Converts the configurations of all Auto-APs being managed
by the UNIVERGE WL Controller into permanent
configurations.