Specifications

set ap auto radiotype
Chapter 12
AP Commands
281
Defaults None.
Access Enabled.
Usage To display the UNIVERGE WL Access Points numbers assigned to
Auto-APs, use the show ap status all command.
Examples The following command converts the configuration of Auto-AP 5 into
a permanent configuration:
PROPMT# set ap auto persistent 5
success: change accepted.
See Also
l set ap auto on page 277
l set ap auto mode on page 279
l set ap auto radiotype on page 281
set ap auto radiotype
Sets the radio type for single-UNIVERGE WL Access Points radios that use the
UNIVERGE WL Access Points configuration profile.
Syntax set ap auto [radiotype {11a | 11b | 11g}]
Defaults The default radio type for models WL1500-AP, WL1500-AP-JP and
WL1700-MS(AP) and for the 802.11b/g radios, or 802.11b in regulatory domains
that do not support 802.11g.
Access Enabled.
Examples The following command sets the radio type to 802.11b:
PROPMT# set ap auto radiotype 11b
success: change accepted.
See Also
radiotype 11a | 11b | 11g Radio type:
• 11a—802.11a
• 11b—802.11b
• 11g—802.11g