Specifications

set ap boot-configuration vlan
Chapter 12
AP Commands
287
See Also
l clear ap boot-configuration on page 273
l set ap boot-configuration ip on page 284
l set ap boot-configuration vlan on page 287
l show ap boot-configuration on page 401
set ap boot-configuration vlan
Specifies 802.1Q VLAN tagging information for a UNIVERGE WL Access
Points.
Syntax set ap ap-number boot-configuration vlan vlan-tag tag-value [mode
{enable | disable}]
Syntax set ap ap-number boot-configuration vlan mode {enable | disable}
Defaults None.
Access Enabled.
Usage When this command is configured, all Ethernet frames emitted from the
UNIVERGE WL Access Points are formatted with an 802.1Q tag with a specified
VLAN number. Frames sent to the UNIVERGE WL Access Points that are not
tagged with this value are ignored.
Examples The following command configures UNIVERGE WL Access Points 1
to use VLAN tag 100:
PROPMT# set ap 1 boot-configuration vlan vlan-tag 100 mode enable
success: change accepted.
ap ap-number Index value that identifies the UNIVERGE WL
Access Points on the UNIVERGE WL Controller.
vlan-tag tag-value The VLAN tag value. You can specify a number
from 1 – 4093.
mode {enable | disable} Enables or disables use of the specified VLAN tag
on the UNIVERGE WL Access Points.