Specifications

set ap name
Chapter 12
AP Commands
290
Usage A change to the forced image download option takes place the next time
the UNIVERGE WL Access Point is restarted.
Even when forced image download is disabled (the default), the UNIVERGE WL
Access Point still checks with the UNIVERGE WL Controller to verify that the
UNIVERGE WL Access Point has the latest image.
The UNIVERGE WL Access Point loads its local image only if the UNIVERGE
WL Controller does not have a newer UNIVERGE WL Access Point image than
the one in the UNIVERGE WL Access Point local storage. If the UNIVERGE
WL Controller has a newer version of the UNIVERGE WL Access Point image
than the version in the UNIVERGE WL Access Point’s local storage, the
UNIVERGE WL Access Point loads its image from the UNIVERGE WL
Controller.
Examples The following command enables forced image download on
UNIVERGE WL Access Points 69:
PROPMT# set ap 69 force-image-download enable
success: change accepted.
See Also show ap config on page 374
set ap name
Changes an AP name.
Syntax set ap ap-number name name
Defaults The default name of a directly attached UNIVERGE WL Access Points
is based on the port number of the UNIVERGE WL Access Points access port
attached to the UNIVERGE WL Access Points. For example, the default name for
a UNIVERGE WL Access Point on UNIVERGE WL Access Points access port 1
is AP01.
Access Enabled.
ap ap-number Index value that identifies the UNIVERGE WL Access
Points on the UNIVERGE WL Controller.
name Alphanumeric string of up to 16 characters, with no spaces.