Specifications

set ap radio channel
Chapter 12
AP Commands
294
Defaults The default channel depends on the radio type:
l The default channel number for 802.11b/g is 6.
l The default channel number for 802.11a is the lowest valid channel number
for the country of operation.
Access Enabled.
Usage You can configure the transmit power of a radio on the same command
line. Use the tx-power option.
This command is not valid if dynamic channel tuning (RF Auto-Tuning) is
enabled.
Examples The following command configures the channel on the 802.11a radio
on the AP 5:
PROPMT# set ap 5 radio 1 channel 36
success: change accepted.
The following command configures the channel and transmit power on the
802.11b/g radio on the AP 1:
PROPMT# set ap 1 radio 1 channel 1 tx-power 10
success: change accepted.
See Also
l set ap radio tx-power on page 297
l show ap config on page 374
radio 2 Radio 2 of the UNIVERGE WL Access Points. (This option
does not apply to single-radio models.)
channel
channel-number
Channel number. The valid channel numbers depend on the
country of operation.