Specifications

set ap radio tx-power
Chapter 12
AP Commands
297
l set radio-profile mode on page 316
l show radio-profile on page 408
set ap radio tx-power
Sets the transmit power of an AP radio.
Syntax set ap ap-number radio {1 | 2} tx-power power-level
Defaults The default transmit power on all AP radio types is the highest setting
allowed for the country of operation or highest setting supported on the hardware,
whichever is lower.
Access Enabled.
Usage You also can configure a radio channel on the same command line. Use
the channel option.
This command is not valid if dynamic power tuning (RF Auto-Tuning) is enabled.
ap ap-number Index value that identifies the UNIVERGE WL Access
Points on the UNIVERGE WL Controller.
radio 1 Radio 1 of the UNIVERGE WL Access Points.
radio 2 Radio 2 of the UNIVERGE WL Access Points. (This option
does not apply to single-radio models.)
tx-power
power-level
Number of decibels in relation to 1 milliwatt (dBm). The
valid values depend on the country of operation.
Note: The maximum transmit power you can configure on
any NEC Networks radio is the maximum allowed for the
country in which you plan to operate the radio or one of the
following values if that value is less than the country
maximum: on an 802.11a radio, 11 dBm for channel
numbers less than or equal to 64, or 10 dBm for channel
numbers greater than 64; on an 802.11b/g radio, 16 dBm for
all valid channel numbers for 802.11b, or 14 dBm for all
valid channel numbers for 802.11g.