Specifications

set ap security
Chapter 12
AP Commands
299
Defaults The default setting is optional.
Access Enabled.
Usage This parameter applies to all UNIVERGE WL Access Points managed by
the UNIVERGE WL Controller. If you change the setting to required, the
UNIVERGE WL Controller requires UNIVERGE WL Access Points to have
encryption keys. The UNIVERGE WL Controller also requires their fingerprints
to be verified in UNIVERGE WL Control System. When UNIVERGE WL
Access Points security is required, a UNIVERGE WL Access Point can establish
a management session with the UNIVERGE WL Controller only if its fingerprint
has been verified by you in UNIVERGE WL Control System.
A change to UNIVERGE WL Access Points security support does not affect
management sessions that are already established. To apply the new setting to a
UNIVERGE WL Access Point, restart the UNIVERGE WL Access Point.
Examples The following command configures a UNIVERGE WL Controller to
require UNIVERGE WL Access Points to have encryption keys:
PROPMT# set ap security require
See Also
l set ap fingerprint on page 288
l show ap config on page 374
l show ap group on page 389
optional Allows UNIVERGE WL Access Points to be managed by
the UNIVERGE WL Controller even if they do not have
encryption keys or their keys have not been verified by an
administrator. Encryption is used for UNIVERGE WL
Access Points that support it.
none Encryption is not used, even for UNIVERGE WL Access
Points that support it.