Specifications

set radio-profile auto-tune channel-config

Chapter 12

AP Commands

302

Defaults

Dynamic channel assignment is enabled by default.

Access

Enabled.

Usage

If you disable RF Auto-Tuning for channels, UNIVERGE WL Control

System does not dynamically set the channels when radios are first enabled and

also does not tune the channels during operation.

If RF Auto-Tuning for channels is enabled, UNIVERGE WL Control System

does not allow you to manually change channels.

Even when RF Auto-Tuning for channels is enabled, UNIVERGE WL Control

System does not change the channel on radios that have active client sessions,

unless you use the no-client option.

RF Auto-Tuning of channels on 802.11a radios uses only the bottom eight

channels in the band (36, 40, 44, 48, 52, 56, 60, and 64). To use a higher channel

number, you must disable RF Auto-Tuning of channels on the radio profile the

radio is in, and use the set ap radio channel command to statically configure the

channel.

Examples

The following command disables dynamic channel tuning for radios in

the rp2 radio profile:

PROPMT# set radio-profile rp2 auto-tune channel-config disable

success: change accepted.