Specifications

set radio-profile auto-tune channel-holddown
Chapter 12
AP Commands
303
set radio-profile auto-tune channel-holddown
Sets the minimum number of seconds a radio in a radio profile must remain at its
current channel assignment before RF Auto-Tuning can change the channel. The
channel holddown provides additional stability to the network by preventing the
radio from changing channels too rapidly in response to spurious RF anomalies
such as short-duration channel interference.
Syntax set radio-profile name auto-tune channel-holddown holddown
Defaults The default RF Auto-Tuning channel holddown is 900 seconds.
Access Enabled.
Usage The channel holddown applies even if RF anomalies occur that normally
cause an immediate channel change.
Examples The following command changes the channel holddown for radios in
radio profile rp2 to 600 seconds:
PROPMT# set radio-profile rp2 auto-tune channel-holddown 600
success: change accepted.
See Also
l set radio-profile auto-tune channel-config on page 301
l set radio-profile auto-tune channel-interval on page 304
l show radio-profile on page 408
name Radio profile name.
rate Minimum number of seconds a radio must remain on its
current channel setting before RF Auto-Tuning is allowed to
change the channel. You can specify from 0 to 65535
seconds.