Specifications

set radio-profile countermeasures
Chapter 12
AP Commands
308
UNIVERGE WL Access Points radios can also issue countermeasures against
interfering devices. An interfering device is not part of the UNIVERGE WL
Control System but also is not a rogue. No client connected to the device has been
detected communicating with any network entity listed in the forwarding database
(FDD) of any UNIVERGE WL Controller in the Mobility Domain. Although the
interfering device is not connected to your network, the device might be causing
RF interference with UNIVERGE WL Access Points radios.
Syntax set radio-profile name countermeasures {all | rogue | configured |
none}
Defaults Countermeasures are disabled by default.
Access Enabled.
Examples The following command enables countermeasures in radio profile
radprof3 for rogues only:
PROPMT# set radio-profile radprof3 countermeasures rogue
success: change accepted.
The following command disables countermeasures in radio profile radprof3:
PROPMT# clear radio-profile radprof3 countermeasures
success: change accepted.
The following command causes radios managed by radio profile radprof3 to issue
countermeasures against devices in the UNIVERGE WL Controllers attack list:
PROPMT# set radio-profile radprof3 countermeasures configured
name Radio profile name.
all Configures radios to attack rogues and interfering devices.
rogue Configures radios to attack rogues only.
configured Configures radios to attack only devices in the attack list on
the UNIVERGE WL Controller (on-demand
countermeasures). When this option is specified, devices
found to be rogues by other means, such as policy violations
or by determining that the device is providing connectivity
to the wired network, are not attacked.
none Disables countermeasures for this radio profile.