Specifications

set radio-profile dtim-interval
Chapter 12
AP Commands
309
success: change accepted.
Note that when you issue this command, countermeasures are then issued only
against devices in the UNIVERGE WL Controller attack list, not against other
devices that were classified as rogues by other means.
See Also show radio-profile on page 408
set radio-profile dtim-interval
Changes the number of times after every beacon that each AP radio in a radio
profile sends a delivery traffic indication map (DTIM). An AP sends the multicast
and broadcast frames stored in its buffers to clients who request them in response
to the DTIM.
Syntax set radio-profile name dtim-interval interval
Defaults By default, AP send the DTIM once after each beacon.
Access Enabled.
Usage You must disable all radios using a radio profile before you can change
parameters in the profile. Use the set radio-profile mode command
.
The DTIM interval does not apply to unicast frames.
Examples The following command changes the DTIM interval for radio profile
rp1 to 2:
PROPMT# set radio-profile rp1 dtim-interval 2
success: change accepted.
Note. The DTIM interval applies to both the beaconed SSID and the
nonbeaconed SSID.
name Radio profile name.
interval Number of times the DTIM is transmitted after every
beacon. You can enter a value from 1 through 31.