Specifications

set radio-profile frag-threshold
Chapter 12
AP Commands
310
See Also
l set radio-profile mode on page 316
l show radio-profile on page 408
set radio-profile frag-threshold
Changes the fragmentation threshold for the AP radios in a radio profile. The
fragmentation threshold is the threshold at which the long-retry-count is
applicable instead of the short-retry-count.
The long-retry-count specifies the number of times a radio can send a unicast
frame that is equal to or longer than the frag-threshold without receiving an
acknowledgment.
The short-retry-count specifies the number of times a radio can send a unicast
frame that is shorter than the frag-threshold without receiving an
acknowledgment.
Syntax set radio-profile name frag-threshold threshold
Defaults The default fragmentation threshold for AP radios is 2346 bytes.
Access Enabled.
Usage You must disable all radios that are using a radio profile before you can
change parameters in the profile. Use the set radio-profile mode command
.
The frag-threshold does not specify the maximum length a frame is allowed to be
without being broken into multiple frames before transmission. The UNIVERGE
WL Access Point does not support fragmentation upon transmission, only upon
reception.
name Radio profile name.
threshold Maximum frame length, in bytes. You can enter a value
from 256 through 2346.