Specifications

set radio-profile max-voip-bw
Chapter 12
AP Commands
313
set radio-profile max-voip-bw
Specifies the amount of bandwidth to reserve for active NEC handset calls on a
radio.
Syntax set radio-profile name max-voip-bw Kbps
Defaults The default is 3000 Kbps.
Access Enabled.
Usage This command applies only to radio profiles with QoS mode
voice-extension.
This command is equivalent to the set radio-profile max-voip-sessions
command. Both commands reserve aggregate bandwidth on a radio profile’s
radios for NEC handsets. In fact, the set radio-profile max-voip-sessions
command is not saved when you save the configuration. Instead, the command is
translated into the equivalent set radio-profile max-voip-bw command, which is
saved in the configuration.
Examples The following command reserves 200 Kbps for VoIP sessions for NEC
handsets. This amount will be reserved on each radio in radio profile rp1:
PROPMT# set radio-profile rp1 max-voip-bw 200
success: max-voip-bw is 200 Kb/s
min-client-rate: 1.0 Mb/s
effective bandwidth: 500 Kb/s
Table 32 describes the fields in this display.
Note. This command is equivalent to the set radio-profile
max-voip-sessions command. (See “Usage”.)
name Radio profile name.
Kbps Aggregate amount of bandwidth, in Kbps, to reserve for all
voice sessions on individual radios. You can specify from 0
to 6000.