Specifications

set radio-profile max-voip-bw
Chapter 12
AP Commands
314
See Also
l set radio-profile max-voip-sessions on page 315
l set service-profile cac-mode on page 341
l show radio-profile on page 408
Table 32. Output for set radio-profile max-voip-bw
Field Description
max-voip-bw Amount of aggregate bandwidth to reserve on each
radio.
min-client-rate Lowest mandatory 802.11g transmit rate configured
on service profiles mapped to this radio profile.
(Another term for this parameter is the nominal rate.)
If no service profiles have been mapped to the radio
profile or the CAC mode is not set to
voice-extension in any of them, the following
message is displayed:
WARNING: cac-mode is not voice-ext in any
service profiles
effective bandwidth Maximum aggregate amount of bandwidth that can
be used on a radio by voice sessions. This is the
estimated amount of a radio’s total bandwidth that
will remain available after overhead such as the
following:
• 802.11 overhead, including retransmissions
• VoIP control packet overhead including RTCP,
and proprietary call/handset controls
If the aggregate bandwidth is more than the effective
bandwidth, the following message is displayed:
WARNING: max-voip-bw is more than effective
bandwidth!
This is not an error condition and UNIVERGE WL
Control System will allow the configuration.
However, it will be possible for a radio to become
oversubscribed, which can reduce voice quality.