Specifications

set radio-profile max-voip-sessions
Chapter 12
AP Commands
315
set radio-profile max-voip-sessions
Specifies the amount of bandwidth to reserve for active NEC handset calls on a
radio.
Syntax set radio-profile name max-voip-sessions max-sessions codec {g.711 |
g.729} sample-period {10 | 20 | 30 | 40}
Defaults This command has no defaults.
Access Enabled.
Usage This command applies only to radio profiles with QoS mode
voice-extension.
This command is equivalent to the set radio-profile max-voip-sessions
command. Both commands reserve aggregate bandwidth on a radio profile’s
radios for NEC handsets. In fact, the set radio-profile max-voip-sessions
command is not saved when you save the configuration. Instead, the command is
translated into the equivalent set radio-profile max-voip-bw command, which is
saved in the configuration.
Examples The following command reserves bandwidth for a maximum of 4
active sessions per radio in the rp1 radio profile, using codec g.711 with sample
rate 10 ms:
PROPMT# set radio-profile rp1 max-voip-sessions 4 codec g.711 sample-period 10
success: max-voip-bw is 486 Kb/s
Note. This command is equivalent to the set radio-profile max-voip-bw
command. (See “Usage”.)
name Radio profile name.
max-sessions Maximum number of active sessions to allow on a radio.
You can specify from 1 to 30.
codec
{g.711 | g.729}
Compression and decompression scheme used for voice
sessions.
sample-period
{10 | 20 | 30 | 40}
The interval, in milliseconds (ms), at which samples are
transmitted.