Specifications

set radio-profile mode
Chapter 12
AP Commands
319
Access Enabled.
Usage Use the command without any optional parameters to create new profile.
If the radio profile does not already exist, UNIVERGE WL Control System
creates a new radio profile. Use the enable or disable option to enable or disable
all the radios using a profile. To assign the profile to one or more radios, use the
set ap radio radio-profile command.
To change a parameter in a radio profile, you must first disable all the radios in the
profile. After you complete the change, you can reenable the radios.
To enable or disable specific radios without disabling all of them, use the set ap
radio command.
Examples The following command configures a new radio profile named rp1:
PROPMT# set radio-profile rp1
success: change accepted.
The following command enables the radios that use radio profile rp1:
PROPMT# set radio-profile rp1 mode enable
rts-threshold 2346 Transmits frames longer than
2346 bytes by means of the
Request-to-Send/Clear-to-Send
(RTS/CTS) method.
service-profile No service
profiles
defined
You must configure a service
profile. The service profile sets
the SSID name and other
parameters.
wmm-powersave disable Requires clients to send a
separate PSpoll to retrieve each
unicast packet buffered by the
UNIVERGE WL Access Points
radio.
Table 33. Defaults for Radio Profile Parameters
Parameter
Default
Value
Radio Behavior When
Parameter Set To Default
Value